Editing UBISS2024-Links
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 2: | Line 2: | ||
== Install the Arduino Nano RP2040 Connect Firmware == | == Install the Arduino Nano RP2040 Connect Firmware == | ||
− | + | * download the firmware for the Arduino Nano RP2040 Connect from https://micropython.org/download/ARDUINO_NANO_RP2040_CONNECT/ | |
+ | * unplug the board from the computer | ||
+ | * force the board in bootloader mode by connecting GND and REC pin with a wire: https://docs.arduino.cc/tutorials/nano-rp2040-connect/rp2040-openmv-setup/ | ||
+ | * plug the board into the USB port on your computer, it appears as a drive in your filesystem | ||
+ | * remove the wire between the GND and REC pin (before you copy the file onto the device) | ||
+ | * copy the firmware you downloaded on the drive that showed up in your file system | ||
+ | * once it is completely copied to the device, unplug the board and plug in again | ||
+ | * now you should be able to use Arduino Lab for Micropython development environment, https://labs.arduino.cc/en/labs/micropython | ||
== alternative == | == alternative == |